ATLAS Collaboration(Aaboud, M. et al), Alvarez Piqueras, D., Barranco Navarro, L., Cabrera Urban, S., Castillo Gimenez, V., Cerda Alberich, L., et al. (2017). Top-quark mass measurement in the all-hadronic t(t)over-bar decay channel at root s=8 TeV with the ATLAS detector. J. High Energy Phys., 09(9), 118–41pp.
Abstract: The top-quark mass is measured in the all-hadronic top-antitop quark decay channel using proton-proton collisions at a centre-of-mass energy of root s = 8 TeV with the ATLAS detector at the CERN Large Hadron Collider. The data set used in the analysis corresponds to an integrated luminosity of 20.2 fb(-1). The large multi-jet background is modelled using a data-driven method. The top-quark mass is obtained from template fits to the ratio of the three-jet to the dijet mass. The three-jet mass is obtained from the three jets assigned to the top quark decay. From these three jets the dijet mass is obtained using the two jets assigned to the W boson decay. The top-quark mass is measured to be 173.72 +/- 0.55 (stat.) +/- 1.01 (syst.) GeV.
|
ATLAS Collaboration(Aad, G. et al), Alvarez Piqueras, D., Cabrera Urban, S., Castillo Gimenez, V., Costa, M. J., Fernandez Martinez, P., et al. (2015). Measurement of the top quark mass in the t(t)over-bar -> lepton plus jets and t(t)over-bar -> dilepton channels using root s=7 TeV ATLAS data. Eur. Phys. J. C, 75(7), 330–36pp.
Abstract: The top quark mass was measured in the channels t (t) over bar -> lepton+jets and t (t) over bar -> dilepton (lepton = e, mu) based on ATLAS data recorded in 2011. The data were taken at the LHC with a proton-proton centre-of-mass energy of root s = 7 TeV and correspond to an integrated luminosity of 4.6 fb(-1). The t (t) over bar -> lepton+jets analysis uses a three-dimensional template technique which determines the top quark mass together with a global jet energy scale factor (JSF), and a relative b-to-light-jet energy scale factor (bJSF), where the terms b-jets and light-jets refer to jets originating from b-quarks and u,d,c, s-quarks or gluons, respectively. The analysis of the t (t) over bar -> dilepton channel exploits a one-dimensional template method using the m(lb) observable, defined as the average invariant mass of the two lepton+b-jet pairs in each event. The top quark mass is measured to be 172.33 +/- 0.75(stat + JSF + bJSF) +/- 1.02(syst) GeV, and 173.79 +/- 0.54(stat) +/- 1.30(syst) GeV in the t (t) over bar -> lepton+jets and t (t) over bar -> dilepton channels, respectively. The combination of the two results yields m(top) = 172.99 +/- 0.48(stat) +/- 0.78(syst) GeV, with a total uncertainty of 0.91 GeV.
|
ATLAS Collaboration(Aaboud, M. et al), Alvarez Piqueras, D., Barranco Navarro, L., Cabrera Urban, S., Castillo Gimenez, V., Cerda Alberich, L., et al. (2016). Measurement of the top quark mass in the t(t)over-bar -> dilepton channel from root s=8 TeV ATLAS data. Phys. Lett. B, 761, 350–371.
Abstract: The top quark mass is measured in the t (t) over bar -> dilepton channel (lepton= e, mu) using ATLAS data recorded in the year 2012 at the LHC. The data were taken at a proton-proton centre-of-mass energy of root s = 8 TeV and correspond to an integrated luminosity of about 20.2 fb(-1). Exploiting the template method, and using the distribution of invariant masses of lepton-b-jetpairs, the top quark mass is measured to be m(top) = 172.99 +/- 0.41(stat)+/- 0.74(syst) GeV, with a total uncertainty of 0.84 GeV. Finally, acombination with previous ATLAS m(top) measurements from root s = 7 TeV data in the t (t) over bar -> dilepton and t (t) over bar -> lepton + jets channels results in m(top) = 172.84 +/- 0.34(stat)+/- 0.61(syst) GeV, with a total uncertainty of 0.70 GeV.
|
ATLAS Collaboration(Aaboud, M. et al), Alvarez Piqueras, D., Bailey, A. J., Barranco Navarro, L., Cabrera Urban, S., Carrio Argos, F., et al. (2018). Operation and performance of the ATLAS Tile Calorimeter in Run 1. Eur. Phys. J. C, 78(12), 987–48pp.
Abstract: The Tile Calorimeter is the hadron calorimeter covering the central region of the ATLAS experiment at the Large Hadron Collider. Approximately 10,000 photomultipliers collect light from scintillating tiles acting as the active material sandwiched between slabs of steel absorber. This paper gives an overview of the calorimeter's performance during the years 2008-2012 using cosmic-ray muon events and proton-proton collision data at centre-of-mass energies of 7 and 8 TeV with a total integrated luminosity of nearly 30 fb(-1). The signal reconstruction methods, calibration systems as well as the detector operation status are presented. The energy and time calibration methods performed excellently, resulting in good stability of the calorimeter response under varying conditions during the LHC Run 1. Finally, the Tile Calorimeter response to isolated muons and hadrons as well as to jets from proton-proton collisions is presented. The results demonstrate excellent performance in accord with specifications mentioned in the Technical Design Report.
|
ATLAS Collaboration(Aad, G. et al), Cabrera Urban, S., Castillo Gimenez, V., Costa, M. J., Fassi, F., Ferrer, A., et al. (2015). Measurement of the t(t)over-bar production cross-section as a function of jet multiplicity and jet transverse momentum in 7 TeV proton-proton collisions with the ATLAS detector. J. High Energy Phys., 01(1), 020–67pp.
Abstract: The t (t) over bar production cross-section dependence on jet multiplicity and jet transverse momentum is reported for proton-proton collisions at a centre-of-mass energy of 7 TeV in the single-lepton channel. The data were collected with the ATLAS detector at the CERN Large Hadron Collider and comprise the full 2011 data sample corresponding to an integrated luminosity of 4.6 fb(-1). Differential cross-sections are presented as a function of the jet multiplicity for up to eight jets using jet transverse momentum thresholds of 25, 40, 60, and 80 GeV, and as a function of jet transverse momentum up to the fifth jet. The results are shown after background subtraction and corrections for all known detector effects, within a kinematic range closely matched to the experimental acceptance. Several QCD-based Monte Carlo models are compared with the results. Sensitivity to the parton shower modelling is found at the higher jet multiplicities, at high transverse momentum of the leading jet and in the transverse momentum spectrum of the fifth leading jet. The MC@NLO+HERWIG MC is found to predict too few events at higher jet multiplicities.
|
