PT Journal
AU Valero, A
   Castillo Gimenez, V
   Ferrer, A
   Gonzalez, V
   Hernandez Jimenez, Y
   Higon-Rodriguez, E
   Sanchis, E
   Solans, C
   Torres, J
   Valls Ferrer, JA
TI The ATLAS tile calorimeter ROD injector and multiplexer board
SO Nuclear Instruments & Methods in Physics Research A
JI Nucl. Instrum. Methods Phys. Res. A
PY 2011
BP 74
EP 79
VL 629
IS 1
DI 10.1016/j.nima.2010.11.113
LA English
DE LHC; ATLAS; Calorimeter; Data acquisition; FPGA; Bit error rate
AB The ATLAS Tile Calorimeter is a sampling detector composed by cells made of iron-scintillator tiles. The calorimeter cell signals are digitized in the front-end electronics and transmitted to the Read-Out Drivers (RODs) at the first level trigger rate. The ROD receives triggered data from up to 9856 channels and provides the energy, phase and quality factor of the signals to the second level trigger. The back-end electronics is divided into four partitions containing eight RODs each. Therefore, a total of 32 RODs are used to process and transmit the data of the TileCal detector. In order to emulate the detector signals in the production and commissioning of ROD modules a board called ROD Injector and Multiplexer Board (RIMBO) was designed. In this paper, the RIMBO main functional blocks, PCB design and the different operation modes are described. It is described the crucial role of the board within the TileCal ROD test-bench in order to emulate the front-end electronics during the validation of ROD boards as well as during the evaluation of the ROD signal reconstruction algorithms. Finally, qualification and performance results for the injection operation mode obtained during the Tile Calorimeter ROD production tests are presented.
ER