Abstract: The energy response of the ATLAS calorimeter is measured for single charged pions with transverse momentum in the range 10<p(T) < 300 GeV. The measurement is performed using 139 fb(-1) of LHC proton-proton collision data at root s =13 TeV taken in Run 2 by the ATLAS detector. Charged pions originating from tau-lepton decays are used to provide a sample of high-p(T) isolated particles, where the composition is known, to test an energy regime that has not previously been probed by in situ single-particle measurements. The calorimeter response to single-pions is observed to be overestimated by similar to 2% across a large part of the p(T) spectrum in the central region and underestimated by similar to 4% in the endcaps in the ATLAS simulation. The uncertainties in the measurements are less than or similar to 1% for 15<p(T) <185 GeV in the central region. To investigate the source of the discrepancies, the width of the distribution of the ratio of calorimeter energy to track momentum, the energies per layer and response in the hadronic calorimeter are also compared between data and simulation.

Abstract: Heavy-flavour hadron production provides information about the transport properties and microscopic structure of the quark-gluon plasma created in ultra-relativistic heavy-ion collisions. A measurement of the muons from semileptonic decays of charm and bottom hadrons produced in Pb+Pb and pp collisions at a nucleon-nucleon centre-of-mass energy of 5.02 TeV with the ATLAS detector at the Large Hadron Collider is presented. The Pb+Pb data were collected in 2015 and 2018 with sampled integrated luminosities of 208 μb(-1) and 38 μb(-1), respectively, and pp data with a sampled integrated luminosity of 1.17 pb(-1) were collected in 2017. Muons from heavy-flavour semileptonic decays are separated from the light-flavour hadronic background using the momentum imbalance between the inner detector and muon spectrometer measurements, and muons originating from charm and bottom decays are further separated via the muon track's transverse impact parameter. Differential yields in Pb+Pb collisions and differential cross sections in pp collisions for such muons are measured as a function of muon transverse momentum from 4 GeV to 30 GeV in the absolute pseudorapidity interval vertical bar eta vertical bar < 2. Nuclear modification factors for charm and bottom muons are presented as a function of muon transverse momentum in intervals of Pb+Pb collision centrality. The bottom muon results are the most precise measurement of b quark nuclear modification at low transverse momentum where reconstruction of B hadrons is challenging. The measured nuclear modification factors quantify a significant suppression of the yields of muons from decays of charm and bottom hadrons, with stronger effects for muons from charm hadron decays.

Abstract: A search for the pair production of heavy leptons as predicted by the type-III seesaw mechanism is presented. The search uses proton-proton collision data at a centre-of-mass energy of 13 TeV, corresponding to 139 fb(-1) of integrated luminosity recorded by the ATLAS detector during Run 2 of the Large Hadron Collider. The analysis focuses on final states with three or four electrons or muons from the possible decays of new heavy leptons via intermediate electroweak bosons. No significant deviations above the Standard Model expectation are observed; upper and lower limits on the heavy lepton production cross-section and masses are derived respectively. These results are then combined for the first time with the ones already published by ATLAS using the channel with two leptons in the final state. The observed lower limit on the mass of the type-III seesaw heavy leptons combining two, three and four lepton channels together is 910 GeV at the 95% confidence level.

Abstract: Several observables sensitive to the fragmentation of b quarks into b hadrons are measured using 36 fb(-1) of root s = 13 TeV proton-proton collision data collected with the ATLAS detector at the LHC. Jets containing b hadrons are obtained from a sample of dileptonic (tt) over bar events, and the associated set of charged-particle tracks is separated into those from the primary pp interaction vertex and those from the displaced b-decay secondary vertex. This division is used to construct observables that characterize the longitudinal and transverse momentum distributions of the b hadron within the jet. The measurements have been corrected for detector effects and provide a test of heavy-quark-fragmentation modeling at the LHC in a system where the top-quark decay products are color connected to the proton beam remnants. The unfolded distributions are compared with the predictions of several modern Monte Carlo parton-shower generators and generator tunes, and a wide range of agreement with the data is observed, with p values varying from 5 x 10(-4) to 0.98. These measurements complement similar measurements from e(+)e(-) collider experiments in which the b quarks originate from a color singlet Z/gamma*.

Abstract: This article presents the results of two studies of Higgs boson properties using the WW*(-> e nu μnu)jj final state, based on a dataset corresponding to 36.1fb(-1) of root s = 13 TeV proton-proton collisions recorded by the ATLAS experiment at the Large Hadron Collider. The first study targets Higgs boson production via gluon-gluon fusion and constrains the CP properties of the effective Higgs-gluon interaction. Using angular distributions and the overall rate, a value of tan (alpha) = 0.0 +/- 0.4(stat.) +/- 0.3(syst.) is obtained for the tangent of the mixing angle for CP-even and CP-odd contributions. The second study exploits the vector-boson fusion production mechanism to probe the Higgs boson couplings to longitudinally and transversely polarised W and Z bosons in both the production and the decay of the Higgs boson; these couplings have not been directly constrained previously. The polarisation-dependent coupling-strength scale factors are defined as the ratios of the measured polarisation-dependent coupling strengths to those predicted by the Standard Model, and are determined using rate and kinematic information to be a(L) = 0.91(-0.18)(+0.10)(stat.)(-0.17)(+0.09)(syst.) and a(T) = 1.2 +/- 0.4(stat.)(-0.3)(+0.2)(syst.). These coupling strengths are translated into pseudo-observables, resulting in kappa(VV) = 0.91(-0.18)(+0.10)(stat.)(-0.17)(+0.09)(syst.) and epsilon(VV) = 0.13(-0.20)(+0.28)(stat.)(-0.10)(+0.08)(syst.). All results are consistent with the Standard Model predictions.